Insert the lock, put out the lock cable (see pic. 8) through the drilled reach-through aperture into the inner door side.
Secure the lock with two screws (assembled).
Mount the lock eurocylinder into the lock and secure it with screw M5x55 (assembled).
Make sure that the lock unfastens with a key and the croos-bar slides into without mechanical hindrance.
Mount external screws M8x30 into the holes drilled for external keyhandle fixing (see pic. 10).
Wind the coupling nuts M8x37 on the external keyhandle screws, adjusting required size according to door thickness (see pic. 10).
Attach the keyhandle without the controlling compartment to the outer door side being guided by the lock eurocylinder apertures and keyhandle fixing.
Put out the lock cable through the drilled reach-through aperture into the inner door side (see pic.10), press closely the keyhandle to the door surface.
Attach the internal keyhandle to the inner door side and connect cables of the lock and the kypad to the controlling board as it is shown at the pic. 11.
If it needs, connect the socket of external connection according to pic. 3.
NB! The first pin is marked by a triangle on the lock socket.
Spread cafefully cables in internal keyhadle case and attach the keyhandle to the door surface.
Fix the keyhandle with screws 0 with internal hexahedron (assembled) on the internal door side.
NB! At mounting do not enable cable to be pulled up and damaged.
Insert batteries.
Make sure that the lock is operating: press *1234567# in sequence on the external keyhandle, trimple left indicator blinking will show the proper lock operation. At closing the door the lock will fasten automatically.
