riff|   lock installation

      Insert the lock into the door groove so that it does not happen damage of the cable.

      Secure the lock with two screws assembled into the delivered set.

Insert the lock eurocylinder into the lock and secure it with the screw М5х55 (assembled).       Make sure that the lock unfastens with a key and the croos-bar moves in without mechanical hindrance.       When the cross-bar is sliding make a marking-out for lanch plate to secure on the door jamb.       Choose a groove 3mm deep to mount the lanch plate being guided by the above-mentioned marking-out.       Drill a hole, 12 mm in diameter, for free magnet inlet and a slot for the cross-bar inlet, 20 mm deep.       Drill a hole, 25 mm deep and 3,5 mm in diameter, for a screw and secure the lanch plate with three screws.       Close the door and check the cross-bar to slide into the lanch plate free.       Put the keyhandle without the controlling compartment to the outer door side being guided by the lock eurocylinder aperture.       Mark holes on the door using apertures for keyhandle fixing as a template.       Take the keyhandle out.       Unscrew and take the lock eurocylinder out. Take the lock out of the door.

Mark holes for the cable outlet on the door in correspondence with pic. 9.       Drill marking holes by the bit, 12 mm in diameter, athwart the door.