Programming is used to
set up the lock modes of operation in order to adapt the lock
to circumstances of its exploitation. By the way programming
is applied to change the technical data: changing the user's
code, switch on/off
the signalling system and etc.
Programming is submitted on
the external lock handle when the door is opened, and the
lock should be switched to the NORM mode (the lock shouldnt
be switched to the OPEN or SHUT modes) and there are no signals
of external controlling system.
ATTENTION!!!
Changing and Setting codes should be carried out only when the door is opened.
Entering the function begins with [Ð], then <mode's number> goes, then [Ð] does, then <mode's parameter> can be setted, then [Ð] goes, then <master code> does (for some functions here is <user's code>) and the algorithm is finished off by [Ð].
Entering function has the following view:[Ñ] [Ð] <mode> [Ð] <master code> [Ð] For some functions the additional parameter is setted:[Ñ] [Ð] <mode> [Ð] <parameter> [Ð] <master code> [Ð]
If entering function is correct the right light indicator of keyhandle will blink by several times. If entering is wrong the indicator will light for a second.
Abbreviations, used to describe the mode's programming:
| [C] |
- Escape; |
| [P] |
- a mode of programming; |
| [ÌC] |
- the master code; |
| [nÌC] |
- a new master code; |
| [UN] |
- a user's number (ordinal - from 1 to 24 - user's number); |
| [UC] |
- a user's code (the code of access of a user); |
| [nUC] |
- a new user's code (this code becomes an usual user's code after its entering into the lock); |
| [T] |
- time (time is setted in seconds at programming of temporal period). |
All actions of setting lock's mode are submitted by pressing of button in a particular sequence and there is no need for you to have programmes, computers, adapters and other stuff!
NB! The lock is supplied by the one code - the master code - 1234567. The user's codes have not been entered. There are no "PIN", "PUK" and other special codes opening the lock!
So we recommend explicitly to change the master code after pressing of the Reset button and also when the lock is installed on the door.
|
