|
ATTENTION! Setting and changing codes must be done by opened the door or set the switcher of the modes of operation in the "OPEN" position.
Function 9:
To switch the confirmation of pressing the buttons by blinking the light-emitting diode on
The function switches confirmation of pressing the keypad's buttons by blinking the light-emitting diode on. The mode has setted by default.
For example, C P 9 P 1234567 P |
Function 10:
To switch the confirmation of pressing the buttons by blinking the light-emitting diode off
The function switches confirmation of pressing the keypad's buttons by blinking the light-emitting diode on. The mode has setted by default.
For example, C P 10 P 1234567 P |
Function 11:
To switch the confirmation of pressing the buttons by the buzzer sound on
The function switches sound confirmation of pressing the keypad's buttons on.
For example, C P 11 P 1234567 P |
Function 12:
To switch the confirmation of pressing the buttons by the buzzer sound off
The function switches the sound confirmation of pressing the keypad's buttons off. The mode has setted by default.
For example, C P 12 P 1234567 P |
NB! After changing of all codes you should make sure codes to be setted correctly. If the lock has
not opened by means of the new code it is necessary to remove lock's cover and hold the "RESET" button pressed for 6 seconds which is situated on the control card under the batteries holder. In this case all previous codes and settings will shift to the initial manufacturer's state.
|
